Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
Long Range Hunting & Shooting
338 Edge goes from 0.4 MOA to 2.0 MOA with same load?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="midgetorama32" data-source="post: 369800" data-attributes="member: 19282"><p>Here is what I have found so far...</p><p> </p><p>There is a lot of residual compound in the recoil lug area. With the fresh bead blasted surface it's very easy to see contact points. The contact on the recoil lug is twisting the action horizontally in the stock so that the right side on the back of the receiver and the barrel shank on the left hand side show major signs of contact against the bedding compound since the bead blast finish has been polished off. </p><p> </p><p>I removed some of it last night and its quite a bit better. I just need to go buy a very small chisel to finish the job. I'm not sure what happened because he uses a jig that aligns the recoil lug. I plan on checking the scope base too. It's a 20 MOA 1 piece base.</p><p> </p><p>Oh well. It will be a while before I can go shoot it again.</p><p> </p><p>Thanks for the advice.</p></blockquote><p></p>
[QUOTE="midgetorama32, post: 369800, member: 19282"] Here is what I have found so far... There is a lot of residual compound in the recoil lug area. With the fresh bead blasted surface it's very easy to see contact points. The contact on the recoil lug is twisting the action horizontally in the stock so that the right side on the back of the receiver and the barrel shank on the left hand side show major signs of contact against the bedding compound since the bead blast finish has been polished off. I removed some of it last night and its quite a bit better. I just need to go buy a very small chisel to finish the job. I'm not sure what happened because he uses a jig that aligns the recoil lug. I plan on checking the scope base too. It's a 20 MOA 1 piece base. Oh well. It will be a while before I can go shoot it again. Thanks for the advice. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
Long Range Hunting & Shooting
338 Edge goes from 0.4 MOA to 2.0 MOA with same load?
Top