Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
338 Edge Chamber Specs
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Edd" data-source="post: 1334986" data-attributes="member: 30592"><p>The 300 gr OTM shouldn't be at the shoulder/neck junction with that reamer. It is .547" from the junction to the front of the freebore. Then you need to add the distance it takes a 1.5° angle to decrease .0005" in diameter, that is about .019". Then you have break in wear. The Berger spec sheet shows that bullet to have a bearing surface length of .515".</p></blockquote><p></p>
[QUOTE="Edd, post: 1334986, member: 30592"] The 300 gr OTM shouldn't be at the shoulder/neck junction with that reamer. It is .547" from the junction to the front of the freebore. Then you need to add the distance it takes a 1.5° angle to decrease .0005" in diameter, that is about .019". Then you have break in wear. The Berger spec sheet shows that bullet to have a bearing surface length of .515". [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
338 Edge Chamber Specs
Top