Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
338 Edge Case sizing the proper way ???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="TMR" data-source="post: 193567" data-attributes="member: 5819"><p>I use the FL sizing die and haven't had any problems. I think some guys have problems if they don't have the expander far enough down in the die. I did have a problem with the die itself. Cases kept sticking in it...even new brass that I was forming. A little polishing with 1000 grit paper took care of that problem and now it works fine. If you use the FL die, run the expander/decapper as far down in the die as you can.</p></blockquote><p></p>
[QUOTE="TMR, post: 193567, member: 5819"] I use the FL sizing die and haven't had any problems. I think some guys have problems if they don't have the expander far enough down in the die. I did have a problem with the die itself. Cases kept sticking in it...even new brass that I was forming. A little polishing with 1000 grit paper took care of that problem and now it works fine. If you use the FL die, run the expander/decapper as far down in the die as you can. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
338 Edge Case sizing the proper way ???
Top