Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
338 edge brass reforming
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="bwest270" data-source="post: 450253" data-attributes="member: 21335"><p>I am attempting to run 300 ultra mag brass (Nosler) through a redding 338 edge die to expand the necks from 308 to 338. I am getting case deformation due to the pressure required to force that case through that die. I am coating the inside of the necks with lube so that isnt the problem. Any suggestions?</p></blockquote><p></p>
[QUOTE="bwest270, post: 450253, member: 21335"] I am attempting to run 300 ultra mag brass (Nosler) through a redding 338 edge die to expand the necks from 308 to 338. I am getting case deformation due to the pressure required to force that case through that die. I am coating the inside of the necks with lube so that isnt the problem. Any suggestions? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
338 edge brass reforming
Top