Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
338/300 RUM reamer recomendation
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="davewilson" data-source="post: 235675" data-attributes="member: 4491"><p>i hate to do this, but i'm going to respectfully disagree with Shawn. of course he has about 100 times more experience with this than i do, but i'll tell you about my "one" example. when i was ordering a reamer for this cartridge, i wanted a no turn neck, and i was told that loaded rounds with the edge, without turning the necks, would be about 365. i ordered a 368 neck and when i measured my Rem brass with a 300SMK in it, it was 368, and yes it was pinching when attempting to chamber. wasn't a big deal, i just take the high spots off so my loaded rounds are 365 and it works well. my point is i consider 369 a little "too tight" for a no turn neck with an edge. again this is my "one" experience but it's been the same with 2 different lots of Rem brass.</p></blockquote><p></p>
[QUOTE="davewilson, post: 235675, member: 4491"] i hate to do this, but i'm going to respectfully disagree with Shawn. of course he has about 100 times more experience with this than i do, but i'll tell you about my "one" example. when i was ordering a reamer for this cartridge, i wanted a no turn neck, and i was told that loaded rounds with the edge, without turning the necks, would be about 365. i ordered a 368 neck and when i measured my Rem brass with a 300SMK in it, it was 368, and yes it was pinching when attempting to chamber. wasn't a big deal, i just take the high spots off so my loaded rounds are 365 and it works well. my point is i consider 369 a little "too tight" for a no turn neck with an edge. again this is my "one" experience but it's been the same with 2 different lots of Rem brass. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
338/300 RUM reamer recomendation
Top