Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300WM - Factory ammo "overpressure" signs
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="entoptics" data-source="post: 1956236" data-attributes="member: 104268"><p>0.018" of case stretch is EXTREME. Also, 0.516 above the belt is quite large, and none of the 4 or 5 belted magnum chambers I have dealt with, leave them that large, even with several firings of fairly saucy loads.</p><p></p><p>As mentioned above, that 0.018 is being taken up right in front of the belt, and will thin the cases significantly. Was the "60 rounds of factory ammo" a different lot/type? If so, it's kinda unlikely there were two bad lots, and instead, the rifle has an overly long, and perhaps fat, chamber.</p></blockquote><p></p>
[QUOTE="entoptics, post: 1956236, member: 104268"] 0.018" of case stretch is EXTREME. Also, 0.516 above the belt is quite large, and none of the 4 or 5 belted magnum chambers I have dealt with, leave them that large, even with several firings of fairly saucy loads. As mentioned above, that 0.018 is being taken up right in front of the belt, and will thin the cases significantly. Was the "60 rounds of factory ammo" a different lot/type? If so, it's kinda unlikely there were two bad lots, and instead, the rifle has an overly long, and perhaps fat, chamber. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300WM - Factory ammo "overpressure" signs
Top