Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300 WSM reloading and chambering problems
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="wbm" data-source="post: 2051554" data-attributes="member: 14158"><p>Been there done that with the 300WSM. Had the same problem with two custom barrels...discovered that the problem was that the headspace on both was set too tight and my dies were not short base so they could not adjust down that much. Solution? I reset the headspace for a bit more "slop". Problem solved!</p></blockquote><p></p>
[QUOTE="wbm, post: 2051554, member: 14158"] Been there done that with the 300WSM. Had the same problem with two custom barrels...discovered that the problem was that the headspace on both was set too tight and my dies were not short base so they could not adjust down that much. Solution? I reset the headspace for a bit more "slop". Problem solved! [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300 WSM reloading and chambering problems
Top