Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300 Win Mag Sizing
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Daerider" data-source="post: 1489591" data-attributes="member: 106638"><p>After initial fire forming, I plan on resizing the cases until they will just drop into the chamber without any friction on the bolt face with the firing pin and ejector spring removed. Typically about .001" to .0015" of bump on a fired case. If I do this, the resizing die does not bottom out on the belt leaving a small portion unsized. Do I need to be concerned with this?</p></blockquote><p></p>
[QUOTE="Daerider, post: 1489591, member: 106638"] After initial fire forming, I plan on resizing the cases until they will just drop into the chamber without any friction on the bolt face with the firing pin and ejector spring removed. Typically about .001" to .0015" of bump on a fired case. If I do this, the resizing die does not bottom out on the belt leaving a small portion unsized. Do I need to be concerned with this? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300 Win Mag Sizing
Top