Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300 RUM Advice.....
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="O&#039;swommie" data-source="post: 1768405" data-attributes="member: 104004"><p>Wanting to finally get this going, to reload for it. Its had about 82 factory rounds down the tube, broke in right. I have been gathering equipment here and there , Have dies, brass a mix of HMS, REM and new Nosler, CCI Mag primers and Berger VLD 210's for hunting. Any brass not shot in my rifle will be full length sized, just want to neck size the ones I've shot. A modified Hornady case and OAL gauge for it. MY die set includes a comp. bullet seater. I don't wanna spend a fortune on presses but would like to set up to deprime , full length size and neck size on different equipment if that makes sense. Get a hand held primer for priming. wanting to go with H1000 for the powder. Texas is warm 9 months outta the year so is that a good choice ? Is the Lee equipment decent as I doubt I'll do more than a hundred or so loads developing my load ? Any help or advice is appreciated men. Thanks</p></blockquote><p></p>
[QUOTE="O'swommie, post: 1768405, member: 104004"] Wanting to finally get this going, to reload for it. Its had about 82 factory rounds down the tube, broke in right. I have been gathering equipment here and there , Have dies, brass a mix of HMS, REM and new Nosler, CCI Mag primers and Berger VLD 210's for hunting. Any brass not shot in my rifle will be full length sized, just want to neck size the ones I've shot. A modified Hornady case and OAL gauge for it. MY die set includes a comp. bullet seater. I don't wanna spend a fortune on presses but would like to set up to deprime , full length size and neck size on different equipment if that makes sense. Get a hand held primer for priming. wanting to go with H1000 for the powder. Texas is warm 9 months outta the year so is that a good choice ? Is the Lee equipment decent as I doubt I'll do more than a hundred or so loads developing my load ? Any help or advice is appreciated men. Thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300 RUM Advice.....
Top