Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
300 PRC Sherman improved or 300 Remington Ultra Mag
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="H59" data-source="post: 1661826" data-attributes="member: 105268"><p>The 300 rum is an overbore cartridge that's a real barrel burner. And like I mentioned, the 300prc s.i. can run factory ammo. The 30 nos I'd need a new reamer made with more freebore to really get full velocity potential. And of course the 28-30 I'd need a reamer made and then re- sizing brass& all that goes with that,turning necks etc. The 300prc s.i. I can order up the dies from Rich S. and rent a reamer and I'm ready to go. That was the reason I decided on it I suppose, was the ease of getting the build finished and shooting and the amount of work that would go into getting ammo loaded& downrange was minimal. Or I could just do my barrel break in with factory loads and start reloading my fired cases for load development.</p></blockquote><p></p>
[QUOTE="H59, post: 1661826, member: 105268"] The 300 rum is an overbore cartridge that's a real barrel burner. And like I mentioned, the 300prc s.i. can run factory ammo. The 30 nos I'd need a new reamer made with more freebore to really get full velocity potential. And of course the 28-30 I'd need a reamer made and then re- sizing brass& all that goes with that,turning necks etc. The 300prc s.i. I can order up the dies from Rich S. and rent a reamer and I'm ready to go. That was the reason I decided on it I suppose, was the ease of getting the build finished and shooting and the amount of work that would go into getting ammo loaded& downrange was minimal. Or I could just do my barrel break in with factory loads and start reloading my fired cases for load development. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
300 PRC Sherman improved or 300 Remington Ultra Mag
Top