Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Chatting and General Stuff
General Discussion
300 PRC dying?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="ARlife4me" data-source="post: 2584033" data-attributes="member: 105694"><p>Before I found the 300nm (404J), I did see the 300lm (also 404J). Both make sense, but the nm has a tad bit more max pressure with a little less powder volume. I haven't invested anything into either yet, but the nm would be my choice over a 300prc. I state that due to a lot more gain between the wm and the nm in a 30cal. I see where McGowen makes a 6.5prc barrel for ar10's. Most likely needing to use 135gr or less bullets even with a m118 mag (2.830" coal).</p></blockquote><p></p>
[QUOTE="ARlife4me, post: 2584033, member: 105694"] Before I found the 300nm (404J), I did see the 300lm (also 404J). Both make sense, but the nm has a tad bit more max pressure with a little less powder volume. I haven't invested anything into either yet, but the nm would be my choice over a 300prc. I state that due to a lot more gain between the wm and the nm in a 30cal. I see where McGowen makes a 6.5prc barrel for ar10's. Most likely needing to use 135gr or less bullets even with a m118 mag (2.830" coal). [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Chatting and General Stuff
General Discussion
300 PRC dying?
Top