Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300 prc bushing size (lapua brass)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="cbuck516" data-source="post: 2751056" data-attributes="member: 122236"><p>I use a 0.334" bushing then a mandrel to set tension from the inside. I use between 0.0015"-0.0035" (going off measured dimensions of sized brass and loaded rounds, not nominal bushing or mandrel size) of tension depending on the bullet. I think if I left the expander ball installed I was getting around 0.0035" of neck tension.</p></blockquote><p></p>
[QUOTE="cbuck516, post: 2751056, member: 122236"] I use a 0.334" bushing then a mandrel to set tension from the inside. I use between 0.0015"-0.0035" (going off measured dimensions of sized brass and loaded rounds, not nominal bushing or mandrel size) of tension depending on the bullet. I think if I left the expander ball installed I was getting around 0.0035" of neck tension. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300 prc bushing size (lapua brass)
Top