Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
30-06 N560 and 215 Berger Hyb
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="bamban" data-source="post: 2658403" data-attributes="member: 17722"><p>Rifle:</p><p>28 inch KBI 10T Serengeti chambered by me</p><p>SRS Ti Pro 3 ST</p><p>Trijicon Tenmile</p><p>700 worked over by me.</p><p></p><p>Loading and shooting on the range worked out a load with N560 and 215 Berger Hybrids. Pressure test at .5 grain increment topped out at 60.5. Initial results with limited data precision node with decent velocity appears to be 59.5. At this powder charge, bolt lift is a finger operation.</p><p></p><p>[ATTACH=full]408391[/ATTACH]</p><p></p><p>In preparation for the load work I prepped LC 67 Match brass. Pocket uniformed, flash holes de-burred, and necks turned to 0.013. Not all areas cleaned up to the thinnest areas, on the average 80% cleaned up. Pocket and neck work all done on the lathe. Here is a short video of neck turning. Mandrel turned insitu, 21st century turning shell holder in the tailstock is used to feed and and extract case. Turned mandrel is only good for this setting. Once taken down, next batch requires a new mandrel to be turned down again.</p><p></p><p>[MEDIA=youtube]hJ_bviBGSDs[/MEDIA]</p><p></p><p>A few minutes ago deprimed the fired cases, all tight.</p></blockquote><p></p>
[QUOTE="bamban, post: 2658403, member: 17722"] Rifle: 28 inch KBI 10T Serengeti chambered by me SRS Ti Pro 3 ST Trijicon Tenmile 700 worked over by me. Loading and shooting on the range worked out a load with N560 and 215 Berger Hybrids. Pressure test at .5 grain increment topped out at 60.5. Initial results with limited data precision node with decent velocity appears to be 59.5. At this powder charge, bolt lift is a finger operation. [ATTACH type="full" alt="20221109_091650.jpg"]408391[/ATTACH] In preparation for the load work I prepped LC 67 Match brass. Pocket uniformed, flash holes de-burred, and necks turned to 0.013. Not all areas cleaned up to the thinnest areas, on the average 80% cleaned up. Pocket and neck work all done on the lathe. Here is a short video of neck turning. Mandrel turned insitu, 21st century turning shell holder in the tailstock is used to feed and and extract case. Turned mandrel is only good for this setting. Once taken down, next batch requires a new mandrel to be turned down again. [MEDIA=youtube]hJ_bviBGSDs[/MEDIA] A few minutes ago deprimed the fired cases, all tight. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
30-06 N560 and 215 Berger Hyb
Top