Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Equipment Discussions
3/8" and 1/2" steel gongs
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="littletoes" data-source="post: 42810" data-attributes="member: 579"><p>Made a "u" shaped hanger out of 1/2" sch 40 pipe. For feet i used 1/2" t's with 15" pieces out both ends. You can make it as long and as tall as you want. The best part is that 3/4" t's will slide right over the half inch pipe. So if you use a 3/4 X 1/2 t you can thread a piece of 1/2" pipe into the t and weld the other end to your gong. Just make the welds as strong as you can! Big rifles break welds! Use mallable fittings not cast, cast fittings are more brittle, in case of an accidental hit.</p></blockquote><p></p>
[QUOTE="littletoes, post: 42810, member: 579"] Made a "u" shaped hanger out of 1/2" sch 40 pipe. For feet i used 1/2" t's with 15" pieces out both ends. You can make it as long and as tall as you want. The best part is that 3/4" t's will slide right over the half inch pipe. So if you use a 3/4 X 1/2 t you can thread a piece of 1/2" pipe into the t and weld the other end to your gong. Just make the welds as strong as you can! Big rifles break welds! Use mallable fittings not cast, cast fittings are more brittle, in case of an accidental hit. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Equipment Discussions
3/8" and 1/2" steel gongs
Top