Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
280AI won't chamber
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="codyadams" data-source="post: 1897641" data-attributes="member: 87243"><p>This. Only thing I would add is measure how much neck tension you have after FL sizing the case, make sure you don't have too much. Measure the case length to confirm that it needs trimmed, and properly chamfer. If you have an abrupt edge in the sleeve that centers the bullet on the seater die, sometimes it can catch the case mouth. On one of my dies that was bad about doing that, I chamfered it slightly with a dremmel so it wouldn't catch the case mouth so badly.</p></blockquote><p></p>
[QUOTE="codyadams, post: 1897641, member: 87243"] This. Only thing I would add is measure how much neck tension you have after FL sizing the case, make sure you don't have too much. Measure the case length to confirm that it needs trimmed, and properly chamfer. If you have an abrupt edge in the sleeve that centers the bullet on the seater die, sometimes it can catch the case mouth. On one of my dies that was bad about doing that, I chamfered it slightly with a dremmel so it wouldn't catch the case mouth so badly. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
280AI won't chamber
Top