Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
28 Nosler problems
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="fmuguira" data-source="post: 1677497" data-attributes="member: 27974"><p>helping friend break in his new Fierce CT Edge in 28 Nosler. He brought me Hornady cases, Retumbo powder and 180 ELDM s. </p><p></p><p>Anyway loaded 77 grs for first round shot, bolt was stuck and finally got open but a pop of hand on final bolt lift. Backed charge down to 75 grs and seated bullet back another .100. Cleaned rifle ( barrel showed minimal copper) and fired another round; Ditto, same problem. So cleaned again and loaded 2 rounds and ran over chronograph... 2850 and two more stuck, hard to extract cases. A bullet does not want to fit in fired case, inside diameter around .284. Anyone else ran into this problem?</p><p></p><p>Thinking brass a little on thick side in neck and chamber possibly on tight side. Case expansion .002 on shoulder and nothing on web, same as unfired. </p><p></p><p>Looking for suggestions. Thinking I might neck turn a couple new cases and see if that solves problem. Sucks that he bought 200 rounds of Hornady brass; wondering if Nosler or Morma brands wouldn't of experienced this problem. </p><p></p><p>BTW, brass weighs 258-260 </p><p>Grs and is roughly .014 thick on the neck. If anyone has a different brand of brass would love to hear your neck thickness. </p><p>Thx !</p></blockquote><p></p>
[QUOTE="fmuguira, post: 1677497, member: 27974"] helping friend break in his new Fierce CT Edge in 28 Nosler. He brought me Hornady cases, Retumbo powder and 180 ELDM s. Anyway loaded 77 grs for first round shot, bolt was stuck and finally got open but a pop of hand on final bolt lift. Backed charge down to 75 grs and seated bullet back another .100. Cleaned rifle ( barrel showed minimal copper) and fired another round; Ditto, same problem. So cleaned again and loaded 2 rounds and ran over chronograph... 2850 and two more stuck, hard to extract cases. A bullet does not want to fit in fired case, inside diameter around .284. Anyone else ran into this problem? Thinking brass a little on thick side in neck and chamber possibly on tight side. Case expansion .002 on shoulder and nothing on web, same as unfired. Looking for suggestions. Thinking I might neck turn a couple new cases and see if that solves problem. Sucks that he bought 200 rounds of Hornady brass; wondering if Nosler or Morma brands wouldn't of experienced this problem. BTW, brass weighs 258-260 Grs and is roughly .014 thick on the neck. If anyone has a different brand of brass would love to hear your neck thickness. Thx ! [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
28 Nosler problems
Top