Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
260 in a 6.5cm chamber?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="highdrum" data-source="post: 2031961" data-attributes="member: 13732"><p>So let me get this straight, you chamber a 6.5cm reamer 80k deep, and bump 260 brass back about 25k with a creed die to where it chambers and call it good? It still sounds like you're gonna be forming them to a point. So might as well just push the creed deep enough to close on a 260 gauge and be done. Get the most of the capacity? I like the long neck of the creedmoor. Maybe I should just do a minimal taper 30° 6.5x55 and be done.</p></blockquote><p></p>
[QUOTE="highdrum, post: 2031961, member: 13732"] So let me get this straight, you chamber a 6.5cm reamer 80k deep, and bump 260 brass back about 25k with a creed die to where it chambers and call it good? It still sounds like you're gonna be forming them to a point. So might as well just push the creed deep enough to close on a 260 gauge and be done. Get the most of the capacity? I like the long neck of the creedmoor. Maybe I should just do a minimal taper 30° 6.5x55 and be done. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
260 in a 6.5cm chamber?
Top