Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
243ai "trim to" length
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="jaybic" data-source="post: 954071" data-attributes="member: 17055"><p>Hello,</p><p> </p><p>I have a question I am hoping some of you .243ai shooters may know the answer to.</p><p> </p><p>I finally got my brass fire formed and am prepping to load as an AI round for the first time and when I got to the trimming them to the same length phase, I realized that there is no "official" trim to length. I was just gonna go with matching them all to the shortest piece but most of them measured 2.022(avg) which btw, I notice is a good bit shorter than the standard .243 trim to of 2.035. Is this an issue?</p><p> </p><p>The shortest piece after trimming measured 2.006(neck was not square and I trimmed very slowly until I could see it was squared up...this appears to be the only piece like this so I tossed it).</p><p> </p><p>Any advice, ideas or thoughts on this?</p><p> </p><p>Thanks for your time fellas,</p><p> </p><p>Jamie</p></blockquote><p></p>
[QUOTE="jaybic, post: 954071, member: 17055"] Hello, I have a question I am hoping some of you .243ai shooters may know the answer to. I finally got my brass fire formed and am prepping to load as an AI round for the first time and when I got to the trimming them to the same length phase, I realized that there is no "official" trim to length. I was just gonna go with matching them all to the shortest piece but most of them measured 2.022(avg) which btw, I notice is a good bit shorter than the standard .243 trim to of 2.035. Is this an issue? The shortest piece after trimming measured 2.006(neck was not square and I trimmed very slowly until I could see it was squared up...this appears to be the only piece like this so I tossed it). Any advice, ideas or thoughts on this? Thanks for your time fellas, Jamie [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
243ai "trim to" length
Top