Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
22x47 Lapua
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="jbone405" data-source="post: 906738" data-attributes="member: 73424"><p>The point of this thread is not to compare the 22x47 to the 22-250AI. </p><p></p><p>The point is for me to have a sounding board about the dies and applicable ways one can reload.</p><p></p><p>I am just looking for straightforward responses to my questions. </p><p></p><p>I appreciate all responses but some are just not helpful. </p><p></p><p></p><p></p><p></p><p>Edd has been a great help with no BS answers.</p><p></p><p></p><p>I was looking at case dimensions last night. The .22 BR neck shoulder junction is at about 1.2" or so. If I was to run it in until it reached the neck shoulder junction of my .223 at 1.56" or thereabouts, would that create a problem with extraction because of the .36" of case without a taper? I beleive they will run a BR reamer in .100 more to make BRX chambers, but this is quite a bit more than that.</p></blockquote><p></p>
[QUOTE="jbone405, post: 906738, member: 73424"] The point of this thread is not to compare the 22x47 to the 22-250AI. The point is for me to have a sounding board about the dies and applicable ways one can reload. I am just looking for straightforward responses to my questions. I appreciate all responses but some are just not helpful. Edd has been a great help with no BS answers. I was looking at case dimensions last night. The .22 BR neck shoulder junction is at about 1.2" or so. If I was to run it in until it reached the neck shoulder junction of my .223 at 1.56" or thereabouts, would that create a problem with extraction because of the .36" of case without a taper? I beleive they will run a BR reamer in .100 more to make BRX chambers, but this is quite a bit more than that. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
22x47 Lapua
Top