Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
.22 Creedmoor, anyone?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="284saum" data-source="post: 1586154" data-attributes="member: 96333"><p>No high pressure signs with any load except an ejector mark on the highest IMR 4955 load</p><p></p><p></p><p></p><p>Varied from below 10, to 40-50 fps on 3 shots</p><p></p><p>All these loads were in virgin brass. Now that the batch is all formed, I will anneal, bump shoulder .002", trim, uniform pockets and flash holes, then get more serious about load development. ES will improve I am sure, and I may try a magnum primer too to compare results</p></blockquote><p></p>
[QUOTE="284saum, post: 1586154, member: 96333"] No high pressure signs with any load except an ejector mark on the highest IMR 4955 load Varied from below 10, to 40-50 fps on 3 shots All these loads were in virgin brass. Now that the batch is all formed, I will anneal, bump shoulder .002", trim, uniform pockets and flash holes, then get more serious about load development. ES will improve I am sure, and I may try a magnum primer too to compare results [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
.22 Creedmoor, anyone?
Top