Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
168 eldm bc
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Canhunter35" data-source="post: 1460426" data-attributes="member: 101677"><p>[ATTACH=full]101542[/ATTACH] [ATTACH=full]101541[/ATTACH] Just shot this at 880, had to adjust my bc, then the wind started switching on me as I laid down the waterline of shots.</p><p>Went with a bc of .259 at 2678fps out of my 308 with the eldm. Was a little low, going to adjust my velocity down to 2670fps. That would put me right in the center of the gong.</p><p></p><p>On a side note, I haven't had the tightest es with this brass. About 30es, but I reamed the flash holes finding a few that were too small. I think the proof is on the target of how that affects the es. This is a mix of federal and Remington brass tossed together. They've had primer pockets levelled, and annealed after the 3rd firing and this is the sixth firing. I'll anneal them again</p></blockquote><p></p>
[QUOTE="Canhunter35, post: 1460426, member: 101677"] [ATTACH=full]101542[/ATTACH] [ATTACH=full]101541[/ATTACH] Just shot this at 880, had to adjust my bc, then the wind started switching on me as I laid down the waterline of shots. Went with a bc of .259 at 2678fps out of my 308 with the eldm. Was a little low, going to adjust my velocity down to 2670fps. That would put me right in the center of the gong. On a side note, I haven’t had the tightest es with this brass. About 30es, but I reamed the flash holes finding a few that were too small. I think the proof is on the target of how that affects the es. This is a mix of federal and Remington brass tossed together. They’ve had primer pockets levelled, and annealed after the 3rd firing and this is the sixth firing. I’ll anneal them again [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
168 eldm bc
Top