22 creedmoor

Like the title says. I’m looking to buy a custom built 22 Creedmoor. I prefer a 20” barrel. However smaller will work. No longer then 20” though please.

Gents - I'm running into some odd issues when it comes to loading for my new 22 Creedmoor. I am consistently seeing ejector swipe and ejector marks across most charge weights, including very light charges that are well under published maximums. At the same time, velocities are abnormally low...

Hello All, Recently I was doing some load development for my 22 Creedmoor. I was using load data provided to me by Berger for their 85.5 gr LRHT bullets. I started at the middle of the charge weight table and worked my way up in 0.3 gr increments to the top. I didn't start to see noticeable...

I’m rebuilding my 7mm-08 into a 22 Creedmoor. I’m just putting on a new barrel and new stock. I believe I have all the info I need to order a barrel from Preferred Barrels. Just going to be shooting factory loads the 80gr Eld-x. I chose the chambering 22Creedmoor a.081”FB. I was looking at...

Howdy All! I have a 20" 22 Creed getting spun up and I want to get a new can for it. I definitely want to go with a titanium suppressor, as weight savings is important to me. Currently, I am deciding between the Dead Air Nomad LTI XC or the TI XC. Any insight into either of these cans or...

Need Advice - 22 Creedmoor Load Development I've got a 22CM 20" barrel getting spun up and I was hoping to get some advice on some load development. My hope was to shoot some of the heavier bullet options like the Berger 85.5 or 90s. I don't have any suitable powder on hand so whatever is...

Im not interested in necking down brass. Alpha munitions, Peterson , ADG & Hornady all have 22 creedmoor brass. Does anyone have a recommendation or experience with mentioned brass. I personally have experience with Hornady brass in other cartridges.

I’m looking at building an AR-10 in 22 creedmoor. I know you should use a small base die when reloading semi/pump/lever action firearms. For those of you currently loading 22 creedmoor for an AR, I’d like to know how you go about this. 6mm Creedmoor small base die? Thanks for the help.

After very scary results with temperature sensitivity using VV550! I'm just starting from square one with load development and have searched several sites and ran on Quickload and have a ton of notes. Now just looking to start with 6 Creedmore Starline SRP brass. Have been using Hornady 6...

I'm starting to collect parts for a 22 Creedmoor build. The action is a standard Savage 12FV in 6.5 Creedmoor purchased at Cabela's during their sale. $269 after rebate is a no-brainer price for a donor action. I am having the action trued up and will be bedding it into either a Savage laminate...