Recent content by wvelk huntr

I can tell you that mine fall out also when taking it apart to clean.....assuminng 7600 and 760 have same bolt carrier.

Try these, seem to remedy the issue to about 9 out of 10. But I always let it beep then check the displayed weight again and adjust if needed. https://www.mkmachining.com/product-category/reloading-accessories/powder-tube-inserts/

I believe this will give you what you are looking for https://bergerbullets.com/information/lines-and-designs/bullet-reference-charts/

I may have missed it, but what bullet were you using?

Merle Haggard -> "Fightin Side of Me"

I know this is an old thread, but it has so much relevant information that it only makes sense to reply to it vs starting a new one. I have a load worked up that I am happy with and have been using for several years and dont see me changing any time soon. It makes sense to me that I could...

Also curious who you gunsmith was, I'm not to far from you and wondering if you used someone local

A wet chamber could give you pressure signs and without an increase velocity. Might be worth checking that the chamber is dry

Yes, he does fine work

https://mcrifles.com/services-%2F-price-list

https://mcrifles.com/services-%2F-price-list Not positive if he can do Tikka's

I cant honestly say whether it did or not, but my guess would be that it would have. I too have since purchased the Teslong borescope.

I had similar issue with my 28 Nosler. Ended up being carbon build up in the lead. What tipped me off was an increase in velocity and hard bolt lift. Then it started to get hard to chamber a round so I ejected a loaded round to inspect it and noticed the marks on the bearring surface of the...

Check out Kevin Cram at Montor County Rifles. He has built a couple for me and I have been happy with them. https://mcrifles.com/