you would think that a setup like he mentioned that both end caps must be welded .
if it was screwed endcap and you removed the body then you just broke the ATF Law ..
like on my YHM the end cap threads are 1.375X24 threads
if your using a rifle lower that was on a 4473 , then just buy a stripped lower
it will be other on a 4473 and build a pistol . that way the suppressor on a form 4
can go on any rifle ,, I would go a 30 cal on your suppressor so it will fit
anything from a 300 WM to a 223/5.56 mm . for myself i...
other than mil spec M193 & M855
I reload my own from 50,55,60 Vmax's all match bullets
from 52 grn to 77 SMK . my barrels are 1-7,1-8,1-9 twist
from 10.5 to 24 inch barrels . on 308 I load from 110 to 175 grn
on 300 WM 190 to 230 grn,
TS2
I made up 2K of Hornady 55 SPBT/C , I used 25.0 H335 with a aol of 2260
using this combo as a base , my AR's and Tikka SV shoots this
combo right at moa in all rifles , with 1-7 & 1-8, 1-9 twist barrels .
out of a 24 barrel 10 shot average. 3158 fps.
out of a 20 inch 10 # A# 3057 fps.
out...
for what your asking just buy a stoner , palmetto state or something used
for a blaster upper , if your wanting a moa barrel it will be in the 250 & up
on money , if your want to try to build to light weight go with a 14.5 pen & weld
Hello
I'm only going to respond to reply's in my posting
have had several offers through emails for F&F through paypal .
if you have what i want reply here , and I will follow up with a
phone call .
Thanks TS2
Jesse