Recent content by t/c fan 1

I have around 5-600 once shot hornady match brass for my .308 win. The brass is from factory ammo (superformance match) and it looks like they may have crimped the primers in? Priming the brass seems sticky and takes a bit of force. Any one seen this?

Thanks Wildrose, After reading your post i checked the mating surface between the action and the bedding block and found excess epoxy in places. Cleaned that up and, so far, point of impact is staying the same. Heading to the range again in the morning to prove it. Hope to gain some confidence...

Sorry... by 2 min. hot i mean 2 moa high.. ( 4'' high @ 200 yds. 8'' high @ 400 ect.) My icon has an alluminum bedding block inside the laminate stock. I torqued the three screws to 50 inch pounds.

Re zeroed two trips ago. Yesterday was two minutes hot but i thought the same as you and did not click at all. Wont be back to the range till next week and thats killing me.:) Will post the results immediately though. thanks for the reply, t/c fan 1

I shoot a t/c icon precision hunter in .308 and use hornady match 178 bthp. The gun shoots 1/2 moa groups 24/7. My problem is that these groups are perfect zero at 200 one day and 2 minutes hot the next! Windage stays the same. So far its allways 2 minutes. Scope is mounted with tactical rings...