Recent content by Punkur67

I have over 2200 rounds on my 6cm with a bartlein 400MODBB barrel. I run 115 DTACS at 3000fps. It has not slowed down in the least bit and still shoots. This was my group at around 2100 rounds

I write the code on the plastic Bins that I store my brass in so I don't need to look it up anywhere. I also put a photo on my phone for backup

Why not stick to H4350? That is the go to for the CM

I love the ZCO MPCT2

I don't have enough. I buy enough powder for the life of a barrel in one lot. One or two jugs is dedicated to each barrel

I wonder if they will offer an option to upgrade your existing MK2

I have been reloading for about 15 years but got real serious about making precision ammo about 2-1/2 years ago. I have had this room set up for about a year now. It does get a little cluttered sometimes but i try to keep it clean. I usually load at least a couple hundred rifle rounds a month...

I wonder what the new version will cost. I showed my buddy the new one and he wants to buy my old MK2 already

Now I'm going to want the new one!

Dasher is the easiest to load for. I'm pretty sure I can measure with a spoon and get single digit SDs.

Exactly what I have. I have 2 actions, one in a lightweight chassis for hunting and one in a heavy weighted chassis for competition. I have a 6 dasher, 6cm, 6.5cm, and 6.5 saum barrel and just swap as needed for my task. This also allowed me to spend more money on better parts. So instead of...

Custom with a quick change barrel setup. Then you can change calibers whenever you want. Best thing I built was a couple quick change rifles. Takes a couple minutes and an Allen wrench to swap.

Doing my best to add dead animals

It's pretty cheap on Amazon https://www.amazon.com/dp/B01L6W7HHE?ref_=cm_sw_r_apan_dp_3JHAK6B4MNYRWDGQRD2P&language=en-US

Thanks