Recent content by prototype427

PM Sent!

Welcome from NW Colorado!

Yep, I need to be a little more active too!

Lots of great people here and tons of information too! Welcome!

Welcome from NW Colorado!

Welcome!

Same problem, been inactive off and on and I just don't post much

Are these still available? I'd be interested in an EP-5 in mill configuration.

+1 :D

Sounds like a good start on what should be a great shooter for you! I am in the process of building a 7 STW myself, hope to get it done soon but I need to get a barrel ordered!

Not much in the way of suggestions, but I am curious what material you are going to use for the action. Will it be heat treated after the machine work is finished or will it be roughed in then treated and finished? Or are you basing it off an action you already have? I am definitely going to...

+2 I would like to mention that a sticky or stuck bolt is the beginning of problems when brass is longer than the maximum length. The bigger picture is that when a round is chambered there is a potential that the brass will not be able to release the bullet before the case fails. The resulting...

+1!! I agree with the exception of the 5th term, by then(3rd or 4th or maybe 5th) he will write an E.O. that will negate future Elections and will appoint himself either as Dictator or King!!.......I was kidding at first but now I think about itlightbulb......... he might actually try that.......

You are right, I actually misread your post. As far as my reference to Fast and Furious I was looking at how far the government would go. Granted the guns were meant to go to Mexico but some wound up here. Guns tracked by the ATF have been found at crime scenes on both sides of the Mexico-United...

I'm curious, how many of you think along these lines? There are two ways to change a society that I know of. First, control the education system. This way is very slow but can be the most effective. Who runs the public school system again? Who sets the curriculum for all schools both public AND...