Recent content by Molock

...sounds great, I’m a Barnes bullet fan. I use their TTSX in my .300 WM. I’ll check online and see what I can work up. Thank you again.

Rob, would you care to share the recipe with the TTSX, rifle, barrel length, power and primer used. Thx

Ovis, Thanks for the reply. What primers are you using? Does the Montana have a 22 inch barrel? I like the Barnes bullets, how did those work out for you? I have found very little information on reloading the Kimber, but am still looking. Thx again.

I’ve used the 120 grn Hornady GMX on deer between 200 and 237 yds, two of 3 DRT. The other went down at 32 yds because I shot it a bit back. The bullet is devastating.

Should have been spelled Molock, my bad. I’ll change it, don’t want anyone sacrificing their children on my behalf for sure...

Thx, long story, great website with lots of info.

Hornady Superformance GMX 120 grainers.....

I have a Model 7 Remington in .260. It works great on deer and hogs using a 120grn Sierra Matchking bullet, little recoil for such a light rifle. I also have a Kimber 84M in 6.5 Creedmoor. I took 3 deer between 200 and 237 yards with it this past November. I used a factory Hornady...

The Hornady Superformance GMX 120 grain bullets do quiet well in my Kimber 84M

Hey Guys, I have a Kimber 84M in 6.5 CM. The 2 powders I have are H4350 and Superformance. I’ve been using Fed 210 Match primers and 120 grn GMX bullets and 123 grn ELD Match as well as the 120 grn Sierra matchking. The Hornady Factory loads (120 grn GMX) shoot sub MOA but I’m having a time...