Recent content by mauser66

I will take this.

Hi, Just after some information regarding which powders would be suitable for 90- 100 grn bullets.

What powder were you using for your load development? And what speeds were you achieving?

What lenght magazines does it take.

Hi, I was just wondering if anyone had a set they want to sell.

I have 6.5 Saum ,7 Saum and 3 sherman Saum based cartridges so I need good brass to future proof my rifles.

Hi, looking for a chassis or stock for a Stiller Tac338 . I will need it to be shipped to my gunsmith in Illinois.

Just bumping a old thread. Alex what size barrel tenon do you suggest using on these actions. Can you get away with a 1.250 barrel or is a 1.350 needed.

Hi, Nice gun. Can you please tell me what the width of the rib is and what does it weigh?

Seconds if possible.

Hi, Would this barrel headspace on a short action origin?

Hi, Just bumping this thread. I was just wondering if anyone could advise me on freebore needed for a reamer set up for Berger 153-156 . Also what neck diameter would be required for Peterson 7mm Rem mag brass necked to 264.

Hi, Any interest in selling some magazine's? I would like to buy 4 .

Hi, I was just after the trim lenght 6.5SST brass. I am forming from 6.5SAUM ADG brass.

What action were you running in it?