Recent content by lyle2231

Pictures?? Please

Adapt, improvise, overcome! “I’ve done so much with so little for so long I can do virtually the impossible with nothing “ LOL

Thinking out loud….If you could find a bore scope that could reveal a potential cause ? Anyway check off one t Drill / tap primer pocket- 1/4x20. Get a deep 1/2” drive socket next thread (a long enough) 1/4x20 hex head bolt through a fender washer, deep socket. Tighten screw slowly. Case...

May I suggest….get on youtube and search for Ultimate Reloader, search for LE Wilson case gauge depth micrometer. After that one look for rcbs P-mic. This should explain things for you. HTH

Check out LE Wilson . Uses case gauge and micrometer units.

When all else fails call Hornady describe the problem and see what they say. 👍

Don’t give up on it. Work your way through the process.

FWIW….I reload for Across the Course matches. 100 rounds. After about 50 pieces I pull the die out, decaping stem then soak in mineral spirits. Cut the top off a empty laundry detergent bottle. Swab out with patches. I use the Frankford Arsenal lube. Works good! Resetting the die I leave...

I had a buddy that had a .240 Rhyne. I recall it being a 7mmMag case necked to 24 caliber. It went somewhere in the neighborhood of 3500 - 4000 fps.? Only thing 100 rounds later that barrel was toast.

Are these the 140 grain bullets?

I don’t see the tri-pod stand in the pic??

Thanks for your reply!

I haven't heard of ppu previously.

Evening friends! Just a curious moment here….. Who makes: Hornady, Nosler, Federal, Sig…. I presume Lapua makes their own as well as Peterson… How about R-P and Winchester? Some light discussion for Thursday evening 😃