Recent content by llklein

27.4 grains benchmark,win brass,fed primers,32g vmax gives me sub .5 groups in two different guns and 4220 fps in the cooper,and 24" cz kevlar is 4002 fps. Not the best load for either, I split the differance so one load worked good in both.both guns liked between 27 and 28g. Cz liked 27.2 best...

thanks alot.i havent had any problems with mine coming loose,i tightened the thumb screw pretty tight though

i seem to have lost the alignment rod for my magneto speed,can anyone measure theirs and let me know how thick it is?thanks

I gotta say I have no regrets about the one I got.i know there was some talk about the retical not working in low light,mine worked just fine this year on my elk hunt.i had to wait for legal shooting time to take the shot at 430 yards.had no problem seeing the little dot.

mind blowing how a man in Ohio thinks he know best how montana,wyoming,idaho ect should run its state.seems we see alot of that know days.id like to see the western states gov. agencies run by folks that actually have lived in the state most/all their lifelightbulbbet a few things would change...

Buy it and cry once then smile every time you shoot it!thats how it worked for me.caution coopers are addictive

i shoot 300 bergers in my savage 338HS and have to load them .050 off the lands to get them to fit in the mag...they are very close in the mag but feed well.my buddies BA and the HS are within .001 of each other to the lands.we havent finalized a load for either gun but the bergers seem to...

i shot my cow at 430 yards with savage 338LM using 300g bergers and 91g of rl25.she was facing me ever so slightly quartered away and the bullet hit her in the chest right ahead of the front leg struck a rib and left about a 1.25" entrance hole.it then hit the heart,there was roughly a fist size...

Enter Me In The Nikon Scope Contest

Enter Me In The Flatline Ops Contest

.830 is what your looking for

we are using rcbs std dies.we pulled the seater out and polished it up a bit in the lathe after marking a bullet and sticking it in the seater i noticed it wasnt touching the bullet it the same place all the way around.its hitting the bullet about 3/16 up from the tip.but was quite abit higher...

im having problems getting consistent oals using the gen2 bergers in my 338lm.we loaded up new lapua brass sized and trimmed and found the oal was varying as much as .010 using a hornaday comparator.i checked the bullet seater tonight to make shure it wasnt pushing off the tip and its not.has...

Enter Me In The Berger Bullets Contest

enter me in the Lapua brass contest