Recent content by kfbrown14

Just to finish up I have only built 2 28s and one 30/28 for various customers and all 3 occasions as I checked the freebore that THEIR reamers cut I was more than slightly amazed at the measurements .130 to .140 as I remember. That's the designers way of dealing with excessive chamber pressure...

Trim the necks .010 short of standard length. Another suggestion I know everyone loves the .015 off the lands but I think you will have less press signs at or just below max loads with shorter AOL.. with very little sacrifice of accuracy . Have you checked you OAL to what your `book` says.? Bet...

me and my gunsmith are about to build a 416 barret on a mcmillian action and a 30 inch schnieder polly barrel customer wants to shoot the hornady 450 gr bullet what i need is an idea for a load want to start with us869 any ideas or known data