My Sendero (7mm Rem) was a tack driver out of the box. It's the second generation HSP stock. I skim bedded it with Devcon and lightened the trigger and am more than happy with it. When the barrel went south I replaced it with a #6 heavy varmint - match grade and it shoots the same as the...
Check the run out on the ones that don't chamber. See if there's a noticable scrape on one side of the bullet (between the ogive and case) after trying to chamber it.
Somethings goofy for sure.
Did you take the die apart and clean it before using it? You should put a little grease on the taper between the sliding sleeve and cripping collet.
If you shake the die it should rattle and the mandrel/primer pin should be loose.
I just checked mine and the...
If the elevated POI falls to the right of center, rotate the scope right. When the scope is then re-aimed at the "plumb" target line the muzzle will naturally follow - in this case, moves to the left.
Just picture the scope mounted 45 deg from bore center. If you rotate it farther left the...
Good read, however there is a misprint in the live fire method.
"If the second group falls to the left or right of center, the scope should be rotated clockwise or counter clockwise respectively" - should read, if the second group falls to the left or right of center the scope should be...
If your clocking over 2900 fps with the 300s I would try backing off until you hit the 2800 - 2850 fps sweet spot. If that dose'nt show an improvement try the 250 MK and Retumbo at around 2950-3050.