Recent content by jneufy

8 months isn't bad. My guy up here took 2 yrs smiths are far and few between. ...especially good ones.

I had the same issue with an sps in 22-250 after filling my shelves with every make of bullet and powder I finally gave up I sent it to my smith and he is currently putting a new tube on it and blueprinting the action. I do know that it was only locking up on one lug and if I pushed a brush...

Ok. Well youve already figured out my suggestion. I was gonna say I ran into the same issue my .338 lapua. I had slight pressure signs but an absolute awsome load so I tweaked the seating depth also my chamber is very tight not allowing me to just kneck size I always have to bump the shoulder...

Are you kneck sizing or full length.

Thanks submoa. I am curious though is that load data for a hornady 285 gr or the Barnes 285 or does it matter. I am sure if I start with starting on either one I should be safe. Thanks again.

I am looking for load data for the 285 gr tac-x bullet .338. I am shooting a .338 lapua with surgeon action and 28" krieger tube bedded in a t4 manners stock. I am limited(due to location) to h1000 and retumbo powder. help in this matter would be greatly appreciated. thanks in advance.

.75 is not a bad group for factory ammo. It wouldn't hurt to skim bed the action as I have done that on the same stock. In the end with mine I rebarelled and had the action blueprinted.......waiting on arrival to try it out.

Always loved reading this forum never actually joined one.... thought i would give it a try. Love long range shooting. Up until now I have been shooting mostly .300 wm and 22-250 just received my long awaited custom built .338 lapua from Joe @ RPS international. I look forward to participating...