Recent content by Jezzro2004

Okay, maybe this will help out some, I measured the case neck of a loaded round and seems good on that point, I was measuring the case neck thickness with the calipers so that ain't working correctly as a dial indicator would I suppose. Here's the loaded round neck measurement

Chambering is 6.5x284 Norma, I did some measuring on what I could this morning, I did noticed that some of my cartridge overall length did vary some from what it was most were 2.160" and no more than 2.164 I'd assume that could cause inconsistencies.. My Wilson neck die has a .293 bushing. I...

So this is the second time I've played with working a load up for my Savage predator hunter 6.5x284. This time around I used the following ingredients: Lapua brass fire formed, uniformed primer pockets, and flash hole. 123 grain Hornady Amax CCI BR2 primers IMR4831 powder Bullets seated .055 off...

Only thing that has me worried now is my scope is bottomed out with 20 moa rail at 100 yards I plan to use 155 gr for long range so I am afriad ill be zeroing at a further distance than 100 yards.

Vote+1 on Savage;) brother-in-law has one in a 25-06, cheap stock, its light and it shoots under an inch on most of the time. Not to knock on Remington (opinion) cause I have had a few that suited me but was more pleased with the savage line of rifles.

Shot this group with some left over bullets I had I seen a post somewhere online that some had good luck shooting 100 yard groups with amax bullets with 43.5 gr varget so I give it a try and the moly coated done the best, I shot this 4 shot group with Lapua Brass, 168gr AMAX Moly, 43.5 Varget...

Small Brief Video