Recent content by IAHNTR

Sounds good. Need to shoot further than 500 though. More like 800.

All I've read (a lot) says the magneto changes POI, but group size is the same. At 500 it changed POI ~3.25 moa high. We were also following a testing procedure that was highlighted by 6.5 guys and is done on the premise that you use the speeds rather than where the bullets print on paper...

Need a little help form my LRH Friends :) Doing load development on my brothers 260 Rem 700 that was a 308 and we put a 260 take off barrel on. Looking for a little advice on where to go from here. I've attached a few graphs showing what we have done so far. Powder is IMR 4350 in 0.2 grain...

I'm running them in a 28 nosler at 3144 with 88.6 rl33 (work up!) and shot a 0.055" group at 100 with it. My twist is 1:8.5 Brux at 28" and I'm at 900' ASL. So, I would think the 1:8.4 should be enough twist going those speeds.

Sold Pending payment.

Item Sold

Ken- Could you shoot me a picture of the regulator please, not urgent. Is there an actual gauge on it and if so, what pressure do you run? Is there any reason a regulator wouldn't fit on a 20# tank? Thanks Hollis

Will do. Thanks for the info. I'll let ya know what I come up with. Annealer should be here mid next week.

Can you provide a company or link to what you're thinking?

Yes, I would keep the tank outside until needed. Timber338 Yeah, I'm looking for something like that, but it needs to "Y" to the 2 torch tips. I'd also like to put a regulator on it to keep the pressure/flames consistent. Not sure if that is needed though.

Has anyone hooked up a single LP tank to the bench source or the like to use instead of the little 3lb green tanks? I want to hook up one 20lb LP cylinder, like the ones on your gas grill, to my Bench Source using 2 torches and am wondering where you got your fittings/hoses and which ones. I...

NF NXS is 5-22x50 with zero stop, 0.25 moa turrets, 20 moa per turn and NP-R1 reticle. Model # C194. Has a slight amount of brass rash on the underside of the windage turret, but ya never see it cause it's on the bottom. I would include the scope and the NF ultralight low rings (as seen in...

6.5x47 Lapua built by Ryan Pierce of Piercision Rifles This is my most accurate, and most fun gun to shoot. Shoots 3 shots in the .1s and 5 shots in the .2s if the shooter does their part. Took an antelope at 612 yds last fall. Have a load worked up with 140 Berger hybrids and h4350. Will send...

Dies and bullets.

Couple more.