Recent content by hudel

Agreed

I wish I could even find H1000. That’s my goto for my 300 wm that I have all my loads figured out on and it’s out of stock everywhere here. I’d definitely buy it.

Lucky for sure

Does it do ballistics calculations

Good to know. I’m gonna hang on to it for a backup powder if I run out of 4350.

Thanks for that! Just curious how temp sensitive it was, are we talking 1 moa off between 0 and 100 degrees or more significant

Anyone tried it in the creedmore with 143 grn eldx bullets? Maybe I dont fully understand quickload, however it show it with better velocity (2493), case fill (101%) and burn (99.9) vs h4350 velocity 2467, case fill 101 and burn 96.3 This is with my 18" barrel, I realize velocity is a little...

I tried H4350 with 180 ttsx and no luck at least on #s. I realize it would like heavier bullets, I’m just perfecting the process before I waste any Berger’s , I have a few hundred 185 classic hunters on the bench and before I waste any I wanna make sure I’ve worked out the variables that I can.

2975, I was using hornady 168 match, ran all the way up to 82.8 testing and no pressure signs I believe I was still below max.

Well fellas, did my rest run of H1000 yesterday to get a flat spot in velocity and settled on 81.4 iirc. Today I took 6 to the field and chronod and ES of 19 and SD of 8.6. I’ll take that. Thanks for all the help

I tried with new and once fired, i did not anneal, no difference in either noted. It is Sig Sauer brass as thats what was available, as far as neck tension I madrel set it and didnt make a difference on ES either

No sir shooting a Tikka, as far as seating length I seated the same length as similar factory rounds, im way off the jam or the lands as the magazine length in a factory tikka wont allow geting there

The Tikka shoots 1 hole groups, Im the variable

Tried it both ways, no difference i could find on these rounds.

As far as neck tension im using a PMA tool expander mandrel as a seperate step, i would think it would be pretty uniform?