Recent content by Grandhunter

  1. G

    I'm Done with a Bipod on My Hunting Gun

    I agree with all, I used mine as a rifle rack when I was resting or glassing. Hunted in Idaho, Montana, and Oregon. Only fired off them at the range.
  2. G

    New rifle problems

    I have had no problems with my Nosler's, I even shoot factory 2nd's. My 270 WSM .65 inch with 150 ABLR 5 shot group at 200 yards. My 7mm Remington mag averaged .75 at 200 with 150 ABLR. My 300 WSM 190 gr ABLR 1.65 inch at 200 is the best I can do with that one. I can hit the small steel targets...
  3. G

    What do you use to clean primer pockets?

    I use my RCBS case prep tool. trues the primer pocket, wire brush for large and small pockets, Chamfering and deburr tools.
  4. G

    Vibrating or Rotary Tumbler

    Use what you have and plug it in outside. less noise and lots of space.
  5. G

    Steady shooting chair

    Yes, Whistle Pigs, Sage Rats, Piute ground squirrels. depends on what state you are in.
  6. G

    Bonded vs Non Bonded - Accubond vs Berger or SST or Ballistic Tip

    When I started hunting with the 270 WSM and The 300 RUM, I had great success with 130gr BT 270, and 180 gr BT 300 RUM. All dead Right There with lots of damage to the lungs, like Jell-O. Ranges were 200 - 400 yards. But one year hunting in Oregon with my 270 WSM the BT exploded. the Black tail...
  7. G

    30-06??

    By the way, welcome to hunting from Idaho. Never to late to start!
  8. G

    30-06??

    A 30-06 will do the job just fine. Been doing it for years and will continue for years.
  9. G

    New to reloading and long range hunting.

    Welcome from Idaho!
  10. G

    Do you use your hand loads to get on paper?

    I pull the bolt, like many have said. fire one shot at 25, adjust scope to that hole. Fire one shot to confirm adjustment, and adjust in it is not. Then move to 100 fire one shot, adjust. Then start my 3 shot groups to finalize zero. Don't shoot factory other than rimfire. Never used more than 6...
  11. G

    WHAT ELECTRONIC POWDER THROWER?

    I Love my RCBS using it for about 20 years, still going strong.
  12. G

    300 WSM and 190 gr ABLR

    I am using WW Brass, sorry I missed that post until now.
  13. G

    300 WSM and 190 gr ABLR

    I got 2922 with 69.0gr RL22, Grouped a little better than yours at 500 meters. Did not think to take a photo of it. I will have to try the RL16 in mine and RL23 once we can get some powder in the world. For now will have to make due with what's on hand.
  14. G

    unknown powder

    What is everyone's favorite load for the 22-250 and 55gr nosler bullets. I have been working with some 380 powder, but just wondering what others found that they liked.
  15. G

    Hard to believe

    I would have to see that, don't think it is in the realm of possibility. Could of happened once and it may have not been the one he was aiming at.
See more

Top