Recent content by fasteddie911

Any suggestions about how to check or fix this? I did change the stock and free floated the barrel along the way. I read that you should tighten the front angled screw down then tighten everything else, but I don't have a torque wrench and just made it as tight as possible. Any suggestions on...

Thanks for the response. I am just wondering how effective culling my components could be since the bullet itself isn't very high-precision and already, without culling, I am getting good groups except for the one flier. So could that one flier be due to components that are so far off from the...

Hi, I've been developing a load for my ruger M77 MKII in .308. I know its not known for accuracy, but i've free floated the barrel and have been trying to get a load for 150gr corelokts. I've been using Fed 210 and IMR4895 and I got the best group around 46gr., by best I mean that it would...

Thanks for the suggestions. It is a marlin 336, and it sounds like I may be expecting too much from it. I was hoping for 1moa, but maybe that's too high of an expectation. I have seen 2moa more consistently and possibly that's as good as it will get. I have a few more loads I'm going to try...

Hi, I have a 30-30 lever action that I'm trying to work up some loads for. This is my first lever action that I'm developing a load for and I have been seeing some stuff that I really haven't seen before and I was wondering if someone could help me understand whats going on. Basically I have...

Hi, I have a 10+ year old ruger M77 MKII .308 with the paddle boat stock. I haven't shot it in a while, but if I remember right I was getting 1"-2" groups with some minimal load development. I have been thinking of using it again and turning it into a more compact rifle, 20" barrel and...