Recent content by dalewrc30

Like Mike says, the only way to know for sure is to measure it. Why trim it if it isnt needed?

The mandrel on a Lee neck sizing collet die is .3055", this is the smallest diameter the neck is compressed down to and the resized brass normally is around .001" smaller in diameter than the projectiles at .3065- .307". I have found these dies neck form cosistently to this size and a lot of...

I understood the Mountain Ti mounts were different to the std A bolt.

I have a Browning Mountain Ti and want to mount an S&B PMII on it. What would be the best solution for mounting the 34mm rings on this?thx.