Recent content by bbowles

zondsix, Thanks for the reply! That will give me more to think about.

I have always just tumbled in vibratory with corn cob and some polish. They come out nice and clean and pretty bright. I tumble before sizing for hour. Then hour after sizing. I sort brass out with media sifter. I wipe cases with towel and ready to load. My question is how will a long range...

So should I just use expander ball on my redding FL bushing die, or remove expander ball and not touch neck id, or use mandrel for ID AFTER FL sizing, or get a lee collet die made for 6.5creedmoor? Never used any of these methods. Always used std FL sizer with expander ball. Thanks for your help.

I have followed this thread closely cause I have a 6.5 CM std reamer being custom built and have been ordering reloading equipment for it. Have always used std FL dies but now I want to learn the finer points in LR shooting and reloading for concentricity. I have a Redding S Type FL die and...

Unless I am misunderstanding your question I believe your answer is on page 38 of manual. I have one of these units and can set it to give me output in actual "clicks" needed for MOA (1, 1/3 or 1/4). The 1/4 MOA gives you the number of "clicks". What I would like to see in this unit is a dot...