Recent content by barnjoer

Correction, I have 179 pieces of 300 RUM brass. $250.00 shipped.

I have 164 once fired Norma 300 RUM brass for sale. It has been tumbled in a wet Tumblr with stainless steel pins and air dried. I can Anneal the brass if someone so desires for it to be done. PM me if interested.

Then they need to move to TEXAS!!

Use some CLR same stuff you would For lime and calcium buildup on faucets and showerheads. Put it on a page run it in and let it soak and then scrub the hell out of it coming back with the Boretec carbon and then eliminator in the barrel. The CLR will help Break up with carbon ring.

Any other ideas in powder choices? My chamber is 2.815” I am loading to 2.800” Have loaded starting at 2.750” & up to where I am now. I also have A neck sizing bushing I am using .002 less than loaded round. Any other help wiuld be great!!

I acquired 5 hundred of the 87 grain Berger VLD/Hunter Bullets is the only reason that I am shooting them.

I have loaded some 10 different 3 shot groups for my Rem. 700!243 with A24”’barrel. I have not found A group that I am satisfied with. I get 2 in almost the same hole then get A flyer that is about 3/4” away.

Wachsmann tell her Congrats!!

I am loading 87gr VMax They work great. It is all in Bullet placement on Deer. Hogs not so much unless you are going to clean & eat them.

Load the 87gr VMax for my Remington R25-243 pushing it with if I remember right I think 40.8gr H380. Have not Chronographed the load yet.

The 2 groups were shot using IMR 4064 powder. Left side was 36.5gr & the right side target was 36.7gr. Bullets seated to 2.800” which is 15,000th off the lans of my Gun. Now backing load 36.6gr IMR 4064 and seat the Bullets at and see how they group. 2.750 - 2.770 2.795- then to 2.810”.

I trued IMR 4451 got more valosity but group opened up to over 1” I use H4350 for my 6XC with A 30” barrel with almost 1 hole at 100. This group is with the 4064.

any one have any experience with the 87gr Berger/Hunter in A 243?? Trying to work up loads. Ended up with over 500 of these bullets. Loading for A Remington 700 243 with A 24” barrel. So far best I have come up with is IMR 4064 at average of 2978fps. Oal of 2.800” This is 15,000” off the lans...

Did I miss what caliber you are shooting these out of?

All are very good calibers for Deer! Still in my opinion the best is the one YOU have confidence in. It also has the have good GLASS on it, because if you can’t see it you can’t hit it! As far as what I think is the Mose versital caliber it would be the 30-06! It has the most wide range of...