Norma Brass

Discussion in 'Rifles, Bullets, Barrels & Ballistics' started by trader388, Dec 27, 2004.

  1. trader388

    trader388 Well-Known Member

    Messages:
    323
    Joined:
    Feb 12, 2004
    Couple of questions about the stuff...

    Does norma punch or drill the flash hole?

    How does it compare to Lapua brass?

    Thanks.
     
  2. Fiftydriver

    Fiftydriver <strong>Official LRH Sponsor</strong>

    Messages:
    6,848
    Joined:
    Jun 12, 2004
    I have not used much Lapua brass. I did work up a load for a customer in a 338 Lapua using Lapua brass it it was very top shelf stuff.

    I have used the Norma brass quite a bit in the form of the 338-378 Wby brass I use for my 338 Kahn. It to is very top end brass. I always check the flash holes for burrs but have yet to find one. Also, there really was not a need to trim the cases because they were all pretty uniform. They are pretty much ready to load as they come.

    Either way, both brands are very good quality brass.

    I am using Norma 338 Lapua brass for one of my larger caliber Allen Magnum rounds which I started development on. I can get the Norma brass a bit lower in price then the Lapua so I am going to see how they perform, I do not have any worries.

    Good Shooting!!

    Kirby Allen(50)