Burris Pos-Align Offset Inserts.

Discussion in 'Long Range Scopes and Other Optics' started by sportmuaythai, Aug 13, 2009.

  1. sportmuaythai

    sportmuaythai Well-Known Member

    Messages:
    121
    Joined:
    May 18, 2009
    Persuant to my other thread regarding 20MOA base& ringset for my Sako with dovetail, I found that the simplest solution would be to use Burris base with Signature rings and Pos-Align Offset Inserts. I'm not familiar with the set-up. Do I need to order just a front or rear insert, or do I need a set of front& rear inserts? With a regular scope mounting, I know that it's critical to have front and rear rings centered so that the scope tube is not stressed. How does the insert system achieve this centered scope rings allingment?
     
  2. winmagman

    winmagman Well-Known Member

    Messages:
    1,379
    Joined:
    Mar 13, 2003
    The Burris inserts are used as sets, a + and - of the same size in the front, the rear, or both if needed.

    Chris
     

  3. sportmuaythai

    sportmuaythai Well-Known Member

    Messages:
    121
    Joined:
    May 18, 2009
    Thank you very much.
     
  4. winmagman

    winmagman Well-Known Member

    Messages:
    1,379
    Joined:
    Mar 13, 2003
    Thats what were here for! :D

    Chris
     
  5. acloco

    acloco Well-Known Member

    Messages:
    502
    Joined:
    Jul 1, 2006
    ...and another tip that is mentioned in the Burris instructions.....MARK your ring tops to the ring bottoms....and front to rear. Burris says they are machined with each other.

    I mark the fronts with a single dot on the front upper & lower....and the rear upper/lower with two dots.