Black hills Brass good or bad question????

Discussion in 'Reloading' started by drewman, Jun 7, 2007.

  1. drewman

    drewman Active Member

    Messages:
    38
    Joined:
    Nov 9, 2006
    Has anyone had trouble with BHA brass?

    I reloaded some for my 7mm that I had fired in the same rifle straight from the factory.

    I was working up a new load for this rifle so I started at the low end in the nosler book for imr 4831 under a 150gr projectile and I used fed 215m. Not what I would think as a hot load. I started with 61gr and on up to 63grs.

    Well ever case split at the neck. Some split just once and some twice.

    If anyone has run into this problem let me know.

    Thanks
     
  2. CatShooter

    CatShooter Well-Known Member

    Messages:
    1,049
    Joined:
    May 8, 2001
    [ QUOTE ]
    Has anyone had trouble with BHA brass?

    I reloaded some for my 7mm that I had fired in the same rifle straight from the factory.

    I was working up a new load for this rifle so I started at the low end in the nosler book for imr 4831 under a 150gr projectile and I used fed 215m. Not what I would think as a hot load. I started with 61gr and on up to 63grs.

    Well ever case split at the neck. Some split just once and some twice.

    If anyone has run into this problem let me know.

    Thanks

    [/ QUOTE ]


    Have you called them???

    .