Badger Ord. 338Lapua magazine

7.62RUM

Member
Joined
Mar 10, 2008
Messages
7
Need some measurements,

Length front to back and width left to right of the magazine body

any help is greatly appreciated
 
thanks i was about to call them, but i figured someone on here would have it. I need to come up with a reason to get the measurements, designing a competing magazine setup isn't what they want to here i am sure
 
If you're going to make a set of bottom metal with their magazines you might want to buy a few of their magazines so you can measure the ones you're going to use.
 
Oh i plan on it i am just trying to get as much work done as i can so i can send it to the machine shop as soon as possible. i actually ordered one today
 
Warning! This thread is more than 15 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top