Badger Ord. 338Lapua magazine

Discussion in 'Equipment Discussions' started by 7.62RUM, Jan 23, 2010.

  1. 7.62RUM

    7.62RUM Member

    Messages:
    7
    Joined:
    Mar 10, 2008
    Need some measurements,

    Length front to back and width left to right of the magazine body

    any help is greatly appreciated
     
  2. woodsja

    woodsja Member

    Messages:
    22
    Joined:
    Dec 18, 2008

  3. 7.62RUM

    7.62RUM Member

    Messages:
    7
    Joined:
    Mar 10, 2008
    thanks i was about to call them, but i figured someone on here would have it. I need to come up with a reason to get the measurements, designing a competing magazine setup isn't what they want to here i am sure
     
  4. woodsja

    woodsja Member

    Messages:
    22
    Joined:
    Dec 18, 2008
    If you're going to make a set of bottom metal with their magazines you might want to buy a few of their magazines so you can measure the ones you're going to use.
     
  5. 7.62RUM

    7.62RUM Member

    Messages:
    7
    Joined:
    Mar 10, 2008
    Oh i plan on it i am just trying to get as much work done as i can so i can send it to the machine shop as soon as possible. i actually ordered one today