A-Bolt trigger adjustment ?

ol mike

Well-Known Member
Joined
Aug 21, 2005
Messages
1,176
Location
not florda
I bought a browning a-bolt 7mm wsm -second hand -so no owners manual.Also looked around on the browning site to no avail.

How do i adjust the trigger ?? Also going to get a timney spring kit at Brownells.Thanks for any help -Mike
 
To adjust the current trigger you simply remove the trigger gaurd and with a very small flat head screw driver turn the screw located in front of the trigger either clockwise or anti clockwise to to tighten or loosen the trigger.
 
Be careful turning that little screw on the back of the trigger, the heads break off easy. You won't break it as long as you don't get rammy. Speaking from experience here.
You usually can't get the trigger set low enough with the adjustment alone but installing the light spring from the timiney trigger kit will make all the difference. Its a fairly easy do it yourself job too.
 
Warning! This thread is more than 18 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top