The bolt face was trued on barrel number 2. This is barrel number 5 so I would think he would check the bolt face each time. His barrels always shoot .1 or less. He rebarreled my .243 and 7 mag and both would shoot .03 @ 100 yds.
Remington 700 picks and choses when to fire
- Thread starter Chesterrose79
- Start date
Help Support Long Range Hunting Forum
It's just a simple wildcat round. Take a 300 win mag and neck it down to a 7 mm. Thus the 7x300 win mag. About 30 fps slower than a 28 Nosler but you get twice the barrel life. A very accurate round for long-range hunting.
Chesterrose79
Well-Known Member
I doubt it. He's been building competition f class riffles for a long time and shot for the team Canada f class team at the worlds.
I got it from Midway USA, but it's now discontinued. This supplier has them:
Ellwood Epps Sporting Goods
Online shopping in Canada for hunting supplies, new and used firearms and bows, rare gun parts and obsolete ammunition. A great selection of fishing, camping and shooting supplies in our Orillia stores, north of Barrie, Ontario.
ha ha - I keep a dime and a quarter on my bench for this.
The dime is for locking the striker back, the quarter I put in my vise, with just a bit sticking out, and use that to pull the cocking piece back, instead of gouging up the edge of my bench.
Muddyboots
Well-Known Member
Yeah, makes a lot of "cents" but I had dimes flying all around, heck they almost made change from bouncing across bench....ha ha - I keep a dime and a quarter on my bench for this.
The dime is for locking the striker back, the quarter I put in my vise, with just a bit sticking out, and use that to pull the cocking piece back, instead of gouging up the edge of my bench.
Harry Knutz
Well-Known Member
That jar full of change I have, Just lost half it's value over the last 2 years!
Huntz
Well-Known Member
Chesterrose79
Well-Known Member
It has a triggertec diamond trigger in it.
Mike Matteson
Well-Known Member
Can't quite tell if the action is open or closed. I tend toward it's closed. Not sure if it's pump or auto. I feel it's a pump. That doesn't matter much. Never look down a barrel with the action closed to start with
.
I've had magazine springs go bad by leaving round in the mag. I don't do that any longer. I may only put in a few rounds in instead of a full mag. Remember the count too.
.
crm3006
Well-Known Member
If you have access to another.308, I would take the rounds that failed to fire, and try them in another rifle. If they fire, you have a bolt spring problem. If they again fail to fire, the problem is with the loads.
I never saw where you answered the question of whether the loads were factory or hand loads. Factory, I would change brands of ammunition, if possible. Handloads? I could write a whole page on what could go wrong!
I never saw where you answered the question of whether the loads were factory or hand loads. Factory, I would change brands of ammunition, if possible. Handloads? I could write a whole page on what could go wrong!
Chesterrose79
Well-Known Member
The ones that failed to fire I ejected them. Waited 30secs or so then loaded them back into the chamber and they fired.I'm leaning towards the primer slid forward on the first strike then fired because the primer was seated properly
This^^^
Weak spring not only contributes to misfire, but will also contribute to inconsistent ignition. The latter is detrimental to precision.
lyle2231
Well-Known Member
It looks like he's got an 870??
