Not sure where to post this RE: 260 remington reloading

[Roofman]

Can I get some feedback?
I have lots of 308 brass, I have some 260 Remington dies , 7mm-08 dies
What do I need to form 308 to 260
Do I need a neck die for 260
Do I need outside next turner?
Any help is appreciated

 

[L0NER]

You can resize with just the Full length 260 dies. You will need to outside neck turn the .308 brass and trim to length.
No outside neck turning with 7-08 or 243 brass.

 

[Roofman]

You can resize with just the Full length 260 dies. You will need to outside neck turn the .308 brass and trim to length.
No outside neck turning with 7-08 or 243 brass.

If you 308 to 7m-08 you still have to turn outside neck
What is the best tool to turn outside neck

 

[L0NER]

I don't shoot a 7mm-08 so I can't answer if the necks need to be turned. I do shoot a 260 and have sense 98 when brass was almost nonexistent. I've used a lot of .308,7mm-08 and 243 brass in my 260s only the .308 brass needed neck turned for use as a 260 case. Do some research on neck turning,watch some YouTube videos and go from there before you decide on buying a neck turning tool.

 

[jpfrog]

Can I get some feedback?
I have lots of 308 brass, I have some 260 Remington dies , 7mm-08 dies
What do I need to form 308 to 260
Do I need a neck die for 260
Do I need outside next turner?
Any help is appreciated

This belongs in the "Rifles, Reloading, Optics, Equipment" section under the "Reloading" header.

 

[Roofman]

I don't shoot a 7mm-08 so I can't answer if the necks need to be turned. I do shoot a 260 and have sense 98 when brass was almost nonexistent. I've used a lot of .308,7mm-08 and 243 brass in my 260s only the .308 brass needed neck turned for use as a 260 case. Do some research on neck turning,watch some YouTube videos and go from there before you decide on buying a neck turning tool.

Ok thank u